Our Products
If you want the convenience and comfort of pure water cleansing at your fingertips – when you absolutely need it most – then you’re at the right place!
All our products carry either 1 or 2 year warranties, and have been extensively tested (under Australian conditions) to ensure they do provide reliable, effective & affordable bidet solutions to meet a wide variety of individual needs.
USABidet Tee Assembly (pressure limiting)
- Model:
- H-12D
- Material:
- Solid brass & chromed brass, tap handle: ABS plastic.
- Thread Size:
- 1/2″ BSP (Tee & Union: 15mm male C).
- Backflow Prevention:
- Single check valve in tap outlet.
- Filter:
- 4370150B filter washer set fitted to base of PSL50.
- Australian Certification:
- Tap complies with AS/NZS3718, Tee and Union with AS3688, PSL50 with AS1357.2.
- Tap Attachment:
- Sealed with PTFE Gas thread tape. Must be turned (clockwise only) to correct position during installation.
- Cistern Attachment:
- Secure and positive watertight attachment, with tapered ‘Kinko’ rubber washer sealing between depression on chromed attachment pipe and cistern valve inlet.
The pressure limiting Tee assembly included in the H-02PL USABidet Kit. Recommended where water pressure is over 500kPa, and essential where a hand-held bidet is to be included in the installation and the incoming water pressure is over 350kPa (Combination Adaptor, Model# H-09 will also be required). Includes the H-11 pressure limiting valve assembly, 1/4 turn isolating tap (with built-in check valve),1/2″ to 3/8″ M/F reducing hex nipple and the chromed copper attachment pipe with nuts, nylon olive and rubber sealing ring. Comes fully assembled and sealed as shown. All fittings sealed with Teflon thread tape must be turned (clockwise only) to the correct position during installation.
Technical specifications for the RMC PSL50 pressure limiting valve can be accessed here (PDF).
Please note that not all cistern valve brands allow sufficient entry of the chromed copper attachment pipe for secure fixing of this Tee assembly (please see the Installation PDF for more details). The chrome attachment pipe is made from annealed copper so it can be easily bent during installation - if this is necessary to allow clearance of a wall tap etc.
Fitting this assembly in-line as shown ensures that the cistern valve itself is also protected from excessive water pressure (which can markedly shorten its life).
This pressure limiting Tee Assembly will normally be required with the USABidet when adding a hand held bidet to the installation.
